Steel Castings Sectional

This Indian standard fifth revision was adopted by the Bureau of Indian standards, after the drawlfinalized by the Committee of section steel castings had been approved by the Council engineering metallurgical division. This standard was first published in 1956 and revised in 1962, 1974, 1982 and 1989. In the review of the standard in the light of the experience gained over the years, the Committee decided that the standard may be subsequently revised. In this revision different clauses have been aligned on the recent standards of steel castings. Amendments No. 1 and 2 have also been incorporated in this revision. “In the preparation of this standard, the assistance has been derived from IS0 3755: 1991 ‘ cast carbon steels for general engineering purposes. For the purposes of deciding if a particular requirement of this standard is met, the final value, observed or calculated, expressing the result of a test or analysis is rounded in accordance with IS 2: 1960 ‘rules for rounding numerical values (revised)’. The number of significant places in the rounded value should be the same as the value specified in this standard.

Standard CASTINGS in carbon steel Indian for General Engineering purposes – Specification 1 scope this standard covers the requirements for the steel castings for general engineering purposes carbon. 2 references the Indian standards listed in Appendix A are needed for this standard complements. 3 terms for the purposes of this standard, the definitions are applicable. 3.1 Cast (Melt) the product of one of the following: 7 MENTIONS command following to be any SPECLFIED for the benefit of the buyer, particulars to be specified when ordering for this specification steel castings.

spacer